DLINK DIR 825M HW: A1 FLASH Wanted!

DLINK DIR 825M HW: A1 FLASH Wanted !!

processor:
RTL8197G

flash/ram:
8/128

SOC and wireless are not supported by OpenWrt so far.

1 Like

even boot?,
i want only boot..

في الثلاثاء، ٣ يناير ٢٠٢٣ ٩:٥٢ ص slh via OpenWrt Forum <mail@forum.openwrt.org> كتب:

If there's no SoC support, what will you be booting?

1 Like

flash was earased totally, and i want to install origin sofware

في الثلاثاء، ٣ يناير ٢٠٢٣ ٤:٥١ م frollic via OpenWrt Forum <mail@forum.openwrt.org> كتب:

Then ask the manufacturer, or ISP, we don't have it.

1 Like

what about this url:

What about it?

seem to be source code on china sites

So compile it, and keep your fingers crossed.

It's not on Openwrt.org and is therefore not openwrt developed or supported.

If you're looking for uboot though that is not an openwrt component. As frollic said to recover the bootloader you must speak to the manufacturer.

ooh, ok
i got it thanks..
but Dlink there is now no support!!!

في الأربعاء، ٤ يناير ٢٠٢٣ ٣:٣٣ ص Jdwl1o1 via OpenWrt Forum <mail@forum.openwrt.org> كتب:

Booting...
init_ram

bond:0x00000005

MCM 128MB

dram_init_clk_frequency ,ddr_freq=1066 (Mbps), 533 (MHZ)

DRAM init disable

DRAM init enable

DRAM init is done , jump to DRAM

enable DRAM ODT

SDR init done dev_map=0xb8142000

Detect page_size = 2KB (3)

Detect bank_size = 8 banks(0x00000002)

Detect dram size = 128MB (0x08000000)

DDR init OK

init ddr ok

DRAM Type: DDR2

DRAM frequency: 533MHz

DRAM Size: 128MB

END SERIAL

Find a friend, with the same device, and ask for a flash dump.

thanks for you'rs value replies..
it seems to be the only solution ...
but i get that the processor is RTL8197G from some info while run the device, but on the board i found this chip: (RTL8367RB) and two other small chips seems to be wireless,
what is the processor ?!
thanks,..

That is just the wired ethernet switch, not the SOC or wifi.

:grinning:
but then no processor,
because i dont see any other chip

only two chips covered (WiFi 2.4, 5ghz),... no processor !!!

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.