Hello,
is it possible to flash the openwrt Firmware over serial?
I have See, that everyone can connect to the Router with a serial TTL adapter.
Over tftp the Firmware can Download over lan in the RAM an then it can be flashed to the nand.
I didnt Know the commands to so that.
perhaps,
but it's not required - https://openwrt.org/toh/d-link/dir-860l_b1
make sure you have the correct revision of the router.
Hello,
i think the Router ist bricked.
For 10 Seconds the orange Led light an then it blink every second and it didnt CAME in recovery Mode.
How i can flash the openwrt Firmware to the nand, If i have a Connection with serial to it.
Post the serial output of when you try to go into recovery.
Hello, this is the output from serial:
and i can do nothing
Do nothing, as in unable to interrupt the boot process?
Hello,
now i have flashed the openwrt firmware via lan with following command:
curl -v -i -F "firmware=@openwrt-21.02.1-ramips-mt7621-dlink_dir-860l-b1-squashfs-factory.bin" 192.168.0.1
The lan cable was broken.
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.