Dhcpc process problems

Hello,
I changed my firmware from gl-ar150 to gl-ar300m16. Everything except small changes (i.e. wireless configuration driver etc) is the same. But I have a problem. The process udhcpc starts to duplicate and many of that processes are generated by the time as the following screen shows:

udhcpc

So as time goes on the system has many of that processes and at gets out of memory.
Is there any idea from where should I start debugging? I logread but couldn't understand much... What could be the reason for this regeneration?

Thanks in advance,
Theo

Never a good idea to install firmware targeted for another device.

My wrong,
Of course the firmware is for the new device. I mean the C executables etc are the same. But the image is build for the new device as needed and configured in make menuconfig.

Nevermind,
I found the problem!

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.