I'm new to OpenWRT and have just installed 23.5.2 "factory" on my Linksys WRT3200acm router. My main reason for doing so is because the stock firmware seems to have quit being updated a number of years ago. I'm a bit confused on how to configure the radios, below is what I have at the moment. I have replaced my the common part of my ssid with "name". They are all the same except for the suffix on 5ghz. I'm really not sure how to best set this up. With radio 1 set to "n" will it not function for a "g" device? I'm not aware of any "a" or "b" devices that would need to use my network. I've already discovered that WPA3 is no go, and I'm using WPA2-PSK. I'm very open to suggestions.
radio0 Marvell 88W8964 802.11ac/n
bssid --------:92 ssid name_5ghz Mode:Master (currently set to "ac")
bssid --------:93 ssid name_5ghz Mode:Master (currently set to "n")
radio1 Marvell 88W8964 802.11b/g/n
bssid --------:91 ssid name Mode:Master (currently set to "n")
radio2 Marvell 88W8887 802.11ac/b/g/n
device not active
bssid is not shown, only "Wireless is Disabled" Mode:Master