sounds like wishful thinking.
I see nothing indicating the other MACs are even hooked up. I see the complete opposite in the OEM bootlog.
I see nothing indicating the other MACs are even hooked up.
Weird. It seems that only setting status = "okay"; to nodes for amac0 and amac1 is not enough to enable them.
The whole test and the result can be seen here.
there’s no indication the hardware is even hooked up.
Look at the OEM bootlog from https://openwrt.org/toh/meraki/mx65w
[ 6.496000] bcm5301x_gmac_init_module: NAPI2_POLL mode
[ 6.500000] bcm5301x_gmac_probe enter name:bcmiproc-gmac0; id:0x0; unit:0
[ 6.504000] NVRAM: map 0x1e0a0000
[ 6.532000] et0: eth1addr not found, ignore it
[ 6.536000] bcm5301x_gmac_probe enter name:bcmiproc-gmac1; id:0x0; unit:1
[ 6.540000] et1: eth2addr not found, ignore it
[ 6.544000] bcm5301x_gmac_probe enter name:bcmiproc-gmac2; id:0x0; unit:2
[ 6.548000] si_doattach chipid: 0x3f05cf1e
[ 6.552000] et2: base_addr (0x18024000) irq (181)
[ 6.556000] etc_gmac_speed default GMAC2 speed: auto
[ 6.560000] etc_attach() mdio_init_time = 5
[ 6.564000] si_doattach: incoming bus is PCI but it's a lie, switching to SI devid:0xcf1c
[ 6.568000] si_doattach chipid: 0x3f05cf1e
[ 6.572000] si_attach socitype(0x3) chip(0xcf1e) chiprev(0x5) chippkg(0x0)
[ 6.576000] et2: chipattach: phyaddr(0x1e)
[ 6.580000] et2: chipattach: Calling robo attach
[ 6.584000] bcm_robo_attach: devid32: 0x10
[ 6.652000] bcm_robo_enable_switch IPROC OTP is not configured, can not determine skuid
[ 6.656000] bcm_robo_enable_switch Northstar Family chip
[ 6.660000] eth0: Broadcom BCM5302x 10/100/1000 Mbps Ethernet Controller 6.30.40 (TOB) (r)
[ 6.664000] eth_mac_proc_create: enter
Anyone built 25.10 with POE support?