Hi a newie question:
When I run system upgrade after following the tutorial I get the following:
sysupgrade /tmp/run/mountd/sda1/openwrt-19.07.0-lantiq-xrx200-bt_ho
mehub-v5a-squashfs-sysupgrade.bin
Cannot save config while running from ramdisk.
killall: watchdog: no process killed
Command failed: Not found
I can browse to the usb and I can see the file exists, the router in a Plusnet Hub.
Thank you in advance.
Ok so I had to move theupgrade file to the /tmp folder per the guide, and I also had to resotre my original backed-up image. I was able to complete the install and I can access the routers settings after rebooting via the web panel.
Do I need to worry about these errors:
CLOCK CPU 500M RAM 250M
secure boot
DRAM: 125 MiB
NAND: ONFI flash detected
ONFI param page 0 valid
NAND device: Manufacturer ID: 0x01, Chip ID: 0xf1 (AMD S34ML01G1)
128 MiB
Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01
nand_read_bbt: Bad block at 0x000002e60000
nand_read_bbt: Bad block at 0x000002e80000
In: serial
Out: serial
Err: serial
Net: Internal phy(GE) firmware version: 0x841b
vr9 Switch
It is normal for a NAND flash to have some bad blocks. A table is maintained so the OS knows not to try to store any data in them. This is just a report of what the table contains.