Can't connect to secured Ubiquity WiFi network

Hi,

I am very new to OpenWRT, so please excuse if this is trivial...

I have a Ubiquity network at home and want to set a GL-AR750S as a wireless bridge for some devices outside. But I want to continue to run the Ubiquity software on my network.

If I setup an unsecured network on Ubiquity, I can connect the router to it.

But I can't figure out how to connect to a secured network. I tried WPA2 and WPA3. I tried all different WPA encryption modes on OpenWRT, but the router never connects. I tried different channels, tried to reduce the width to 20 MHz, just to make sure that there aren't any overlaps.

I searched on this forum, but couldn't find any entry...

Any pointers to posts or how to set this up are welcome.

Thanks
Mark

What version of OpenWrt are you using?

Please run the following commands (copy-paste the whole block) and paste the output here, using the "Preformatted text </> " button:
grafik

ubus call system board