Hi, I have Dlink DAP-1320 B1 and I'd like to build openwrt firmware for this device.
Hi All
I would like to install OpenWrt on Dlink DAP-1320 A2. I was trying to find any information if anyone was trying to install alternative firmware on this device, but didnt found anything. Did some of you can advice which version of OpenWRT i should install and if there might be some problems after installation?
it seems that there is support for it. So how do I go about using this to make a build?
committed 04:59PM - 24 May 20 UTC
The DAP-1320 is an N300 repeater that comes in a tiny wall plug case.
Specifica… tions:
* AR9341 / QCA9533, 8 MiB Flash, 64 MiB RAM
* Since this device has no ethernet port, wifi is enabled on boot
using the default credentials as printed on the label
* DAP-1120 A1 is the US black case variant of DAP-1320 Bx
Installation:
* Web UI: http://192.168.0.50 (or different address obtained via DHCP)
Also reachable via dlinkap.local and dlinkapXXXX.local,
XXXX being the last octets of the MAC address, as seen in the ESSID
There is no password set by default
* Recovery Web UI: Keep reset button pressed during power-on
until LED starts flashing red, upgrade via http://192.168.0.50
Please note that at the current stage of discussions regarding devices
without ethernet ports, this device will not be officially supported.
Also failsafe mode is currently not accessible,
if you lock yourself out of the device, just reflash using the Recovery.
Signed-off-by: Sebastian Schaper <openwrt@sebastianschaper.net>
Thank you!