Unfortunately I ripped off the boot_sel2 solder pad, the tx/rx/gnd are soldered fine and I get an output in my terminal but I can't short to trigger the uart, it's just booting normally. I thought I could just short to the R45 resistor instead but that's not working for some reason on either side of the resistor. This is what I'm getting.
ROM VER: 1.1.4
CFG 06
NAND
NAND Read OKDDR autotuning Rev 0.3d
DDR size from 0xa0000000 - 0xa7ffffff
DDR check ok... start booting...