[BPI-R3] My ONU MA5671A doesn't work, but works on Mikrotik RB4011

Installing and Using OpenWrt
21

yes, I'm connected to my ISP with this SFP Transeiver.

My ISP is not using a shared passive GPON port. My ISP provides a AON fiber connection port.

22

ok i understand.

23

hooo i just discovered this today :
https://forum.mikrotik.com/viewtopic.php?t=116364&sid=982e9b20b2be05255ff7d278cdf1a6cc

  1. G-010S-P and other models will not expose ethernet interface unless fiber cable is connected (link-ok, rate 1Gbps)

:upside_down_face:

i made most of my tests without the fiber cable attached to the ONU

EDIT:
still no luck, even starting up with the fiber connected, it's the same thing :sob: :sob:

24

Hi just to keep you upto date.
yesterday i installed debian on the BPI R3, and it recongized successfully my ONT.
i used the debian iso from the wiki here :

the reasons for this problem have been explained here :

I hope this helps you. The openwrt firmware need to be improved...

1 Like
25

finally we found the root cause of my problem :

all you had to do was connect the fibre, without which it was impossible to ping the module!

I didn't want to cut the internet during my tests, so I kept my fiber on my main router... :joy: i wasted 10+ days on this :zipper_mouth_face:

2 Likes
26

It turns out that phylink does not set the link up, if the LOS signal is active.

The LOS signal will only go low, when the fiber is connected and has a signal.

1 Like