Hello everybody i hás try by uart but router is blocked now on led blue on USB
your device photos are useless, feel free to delete them, they're just a waste of bandwidth.
installation and recovery are both via UART - https://github.com/openwrt/openwrt/pull/20398.
we have no idea what you did (and didn't do), crystal ball's offline.
2 Likes
Ok thanks for the page, but I don’t see where TX, RX and GND are on the router. It’s not labeled I see the 4 holes, but how do I know which is which? Thanks.
it's on the page you were given and didn't read.
What makes you think I didn’t read it
because it answers your question.
sorry can you explain
what part of
heatsink
| |
| |
| | +----+-----+------+-------+ +-----------------+
| | | TX | RX | GND | +3.3V | | power connector |
+---+ +----+-----+------+-------+ +-----------------+
|
Don't connect ----+
is hard to understand ?
yes i d’idnt understand
what didn't you understand ?
you have the device in front of you, the holes/pads are between the power connector and the heat sink, pin out is in the link, what's the tricky part ?
2 Likes
As mentioned/showed on the drawing.
If you are using an USB-->Serial adapter that is powered from the USB side ...
Then DON'T connect the USB-->Serial adapter to the +3.3v pin on the router board.
Just connect TX, RX & GND
1 Like
... which is also in the drawing ,)
Yup .. I even referred to it in my post (bold top line).
1 Like
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.