So, finally i'm updating from 22.03.3 to 22.03.5 and have one question regarding attended sysupgrade.
For my two Archer C6 i just used the sysupgrade image and everything went fine.
My main router is a FUTRO S920 though and i installed it with a custom image with bigger rootfs because i planed to run HA on it:
root@OpenWrtMain:~# df -h Filesystem Size Used Available Use% Mounted on /dev/root 4.0M 4.0M 0 100% /rom tmpfs 3.7G 1.2M 3.7G 0% /tmp /dev/loop0 2.0G 221.9M 1.8G 11% /overlay overlayfs:/overlay 2.0G 221.9M 1.8G 11% / /dev/sda1 126.0M 5.2M 118.2M 4% /boot /dev/sda1 126.0M 5.2M 118.2M 4% /boot tmpfs 512.0K 0 512.0K 0% /dev
I probably won't do that anymore, so i guess i technically don't need the bigger partition anymore (although of course it would be nice to keep it!).
I'm unsure now if the attended sysupgrade with asu will work in my case and just reduce the size to default or if i have to expect some issues? I only found this thread that doesn't really clear up things for me tbh ^^
So my core question is: can i use attended sysupgrade without too much of a worry or would it be better to read into the image builder stuff again and build a new custom image? (and of course this time better document what i did with it -.-)
In the latter case, i'm also a bit confused because the output of the imagebuilder doesn't generate a ...sysupgrade.bin like is available for the C6 - so should i just use the same image as for installation? Or the ...-generic-kernel.bin? Or does that not work with LuCI and keeping the config?
Thanks in advance!