Asus TUF AX4200 support

[gwapenut]

Has anyone upgraded to v25.12.0 on the TUF-AX4200 yet, via attended sysupgrade?

[KernelKlink]

I used OWUT from 24.10 to 25.12 RC5 to 25.12.0.

[JonSnow]

had no internet on my AX6000 after upgrade

[HiassofT]

both AX4200 here are working fine with 25.12.0 (updated 2 days ago) - I use imagebuilder though.

so long,

Hias

[gwapenut]

Is that this problem coming back?

Asus TUF AX4200 support

I have the same issue as @Drop afer using an attended sysupgrade to go from 24.10.1 to 24.10.2. I can connect via ethernet, but there is no internet now even though my ISP router is still connected to the WAN port. On the openwrt status page, it says eth1 has "no link" but it is connected to the ISP router. And for wireless connections, the DHCP server doesn't seem to be working at all. What are the routes to getting back to the working configuration? Can I just flash a new 24.10.1 image (o…

[JonSnow]

I don’t think its the same, i didn’t even have the upstream ipv4/6 section in status page.

[Drop]

yes i always the problem impossible to flash the new firmware whilde 23.05

my router brick always

[frollic]

sorry for the delay, wiki page updated.

please confirm the Q TRX image is the correct one.

[remittor]

@frollic

please confirm the Q TRX image is the correct one.

You can also specify this as an additional option (many people trust GitHub more):

Releases · openwrt-xiaomi/builder

[variant6]

I had the same but it on the ISP side and not ax4200 unique.
This workaround + setting the default DUID to blank fixed it.

Problem with DHCP client and forced ClientID in v25.12

Hi OpenWRT community! After v25.12 I can’t obtain a IP via DHCP from my ISP. I found where is the problem. The flag -C on udhcpc request is missing. I remove in /lib/netifd/proto/dhcp.sh lines 68 and 69 and restore from v24.10 line 54 instead. Removed lines: [ -z "$clientid" ] && clientid="$(proto_dhcp_get_default_clientid "$iface")" [ -n "$clientid" ] && clientid="-x 0x3d:${clientid//:/}" Replaced with this line from v24.10: [ -n "$clientid" ] && clientid="-x 0x3d:${clientid//:/}" || c…

Otherwise 25.12 is working fine.

The spi-max-frequency is still the old low value though. I still haven’t had time to build and benchmark, can someone get it tested and pushed?

[KernelKlink]

I’m on 25.12 snapshot from yesterday. Android devices are connecting only at 20 mhz 5ghz. Other devices are connecting at 160 mhz. Is this an Android issue or OpenWRT issue? I noticed the other day on a earlier 25.12 snapsot that Android devices were connecting at 80 mhz.

[lobopt77]

@KrypteX

strings /dev/mtd0 | grep "U-Boot 20"

Hi.
I'm having the same issue. I add Vlan Ids and the applied configurations do not save and always revert. Tried several times and always the same result. Its a new bootlader 2022.10, and already flashed the latest snapshot, with customize and request build.