Askey rt4230w ath10k firmware crashed

hmm... looking at iw list it would seem it should not be capable as you say.
Supported Channel Width: neither 160 nor 80+80

very odd.

Wiphy phy0
	wiphy index: 0
	max # scan SSIDs: 16
	max scan IEs length: 195 bytes
	max # sched scan SSIDs: 0
	max # match sets: 0
	RTS threshold: 784
	Retry short limit: 7
	Retry long limit: 4
	Coverage class: 0 (up to 0m)
	Device supports AP-side u-APSD.
	Available Antennas: TX 0xf RX 0xf
	Configured Antennas: TX 0xf RX 0xf
	Supported interface modes:
		 * IBSS
		 * managed
		 * AP
		 * AP/VLAN
		 * monitor
		 * mesh point
		 * P2P-client
		 * P2P-GO
		 * P2P-device
	Band 1:
		Capabilities: 0x19ef
			RX LDPC
			HT20/HT40
			SM Power Save disabled
			RX HT20 SGI
			RX HT40 SGI
			TX STBC
			RX STBC 1-stream
			Max AMSDU length: 7935 bytes
			DSSS/CCK HT40
		Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
		Minimum RX AMPDU time spacing: 8 usec (0x06)
		HT TX/RX MCS rate indexes supported: 0-31
		VHT Capabilities (0x339b79b2):
			Max MPDU length: 11454
			Supported Channel Width: neither 160 nor 80+80
			RX LDPC
			short GI (80 MHz)
			TX STBC
			SU Beamformer
			SU Beamformee
			MU Beamformer
			MU Beamformee
			RX antenna pattern consistency
			TX antenna pattern consistency
...

Spec on the internet says 4 antennas 80MHz, maybe some manufacturing deviation they left some calibration bits in some devices to allow 160MHz....

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.