Aruba 303H Poe Configuration

[Julius1078]

After installing openwrt on an aruba device (303H) I have not been able to configure or find how to enable PoE on the port supposedly enabled for it.

gpiochip is available and it is possible to interface with the numbers 412 to 411 but it doesn't seem to have any effect.

Has anyone managed to get it to work?

[jjwATmyself]

This may now be solved over here:

Aruba AP-303H DSA is here and better dumb AP

Yes. I can control (enable/disable) the POE on port 3. first find the gpio base cat /sys/class/gpio/gpiochip*/base | head -n1 that is 412. in the dts file I found this: +&tlmm { + /* + * In addition to the Pins listed below, + * the following GPIOs have "features": + * 39 - out - active low to force HW reset + * 32 - out - active low to reset TPM + * 43 - out - active low to reset BLE radio + * 41 - out - pulse to set warm reset status + * 34 - out - active low to enable PSE port + …

[Julius1078]

Tested with an Meraki mr33 (as Poe client) and works like a charm.