Hi folks,
My router is currently with firmware 1.0.17 and I want to test 1.0.67 and the 160Mhz support added back in 1.0.50.
If i do that can I easily downgrade back to 1.0.17 or any other version that you can get the ssh access without the need of serial adapter?
So, after messing around with u-boot to fix the ubi error 22 in the previous post I had power outage while editing the ubi partition.... as some of you guessed I'm now the proud owner of a dead AX3600. with the only chance of turning it back to a router being some soldering sheningan with the flash chip.
therefore, unless someone has suggestions, my fun with this router ends here.
Finally got my AX3600. Instead of multiple commands for web-injections, you can use one command which will fetch the script from https://dev.melmac.net/ax3600.sh and run it on the router:
In my blurry morning eyes I read that as melkur.net and we all know what's hiding in that, tapping the power of The Source..code (yikes, morning puns are bad)!
just wondering what's happening with support for this device. There was a point when this thread was very active. Is it possible to get support eventually?