Adding OpenWrt support for Xiaomi AX3600 (Part 1)

[juppin]

@mgiganto

I just got my RAX120 and I wonder, do I need an FTDI with 1.8v for the console? Or can I use 3.3?

Take your multimeter and check the voltage on your serial pin header...

@mgiganto

I am asking because I don´t know very well when you talk about the xiaomi or the netgear device...

This thread title is "Adding OpenWrt support for Xiaomi AX3600" so i guess it's about this device exclusively...

@mgiganto

The repository that you have been mentioning is for the netgear or xiaomi?

Same as above...

For a generic ipq807x discussion, you should head over to:

IPQ807x SoC Investigation / Status [WIP]

Hello all, Im making this thread to make a central location for IPQ807x SoC information / status outside of the AX3600 thread. I have been working on the Xiaomi AX3600 device alongside @gmzhu , the current status of the HW is Working Linux Boot Nand LED's Ethernet Ports (lots of thanks to @gmzhuo for getting this working) Q6 firmware loading ath11k loads / inits OK Not Working / Not Done PCIe (tho this could be just the AX3600) Switch / VLAN setup WiFi caldata extract from ART Wifi AP (bs…