The content of this topic has been archived on 17 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hi 
I'd like to use Kamikaze on an Linksys AG241V2-DE.
It's on the box and running (r9972). Unfortunetly the network interface does not work.
The switch itself works (two connected computers can send data to eachother)
The output of ifconfig eth0 is a bit strange:
RX bytes:839932 (820.2 KiB) TX bytes:0 (0.0 B)
what can I do?
thanks
rene-roger
boot log and ifconfig output is here
http://pastebin.ca/835288
if the AG241V2 switch chip is an ADM6996L like on wag354g, you have to patch the cpmac driver:
Yes, it's a ADM 6996LC.
I patched the cpmac.c but it did not help.
Has anyone OpenWRT running on an AG241v2?
Yes, it's a ADM 6996LC.
Has anyone OpenWRT running on an AG241v2?
I have an Dlink DSL-684 (which has the ADM6996LC chip too) and the same problem. For me an older release (r10339) did the trick. It seems that the cpmac driver is broken in newer releases.
The discussion might have continued from here.